Not sure if it maters but this is on a delta running an Azteeg X5 with a direct extruder. If I set the wall thickness to 0.45mm and leave the extrusion multiplier at 100% then the wall thickness increases to around 0.55mm.Īny suggestions on how to handle this? I've thought about increasing the infill width to somewhere around 120% but that seems like I'm just chasing the root cause. I'm not really sure where to go from here. Wall thickness and wall line count This setting adjusts the thickness of the walls of the model. Example: Use two colors of the same material to create outlines on 3D prints. It can be set for the inner or outer wall separately. However now there are gaps in the infill. Knowledge Wall extruder This setting defines which extruder should print the walls. Measured wall thickness very close to 0.35mm. Adjusted the extrusion multiplier to get down to 0.35 wall thickness (in my case that was 78%) Measured the wall thickness as 0.45ish (can't recall exactly, that was at 2am). Printed a single perimeter cube with 2 bottoms to check the infill as well as perimeter Then adjust the extrusion multiplier to hit this value. I believe conventional knowledge is to leave the wall thickness at the nozzle diameter (0.35mm in my case). I have the steps/mm set correctly but I can't seem to get the wall thickness and extrusion multiplier worked out. I'm trying to get my new printer dialed in but I can't seem to find a set of settings that works for everything.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |